After You Assemble The Frame There Are Two Syles Of Hanging Your Plant Discribed Below

Frame With One Set of Side Tube

To use one row slide one set of the side tubes to the corner connectors and slide the other set of tubes to the middle

If you use the one tube set hanging style Still attach the other set of side tubes to the frame next to the set in the middle that you are going to use

Frame in Tent With One Set of Side Tubes With Plant Hanging in it

The benefit of this configuration is you can hang bigger branches or whole plants (plant size dependent) Ideally this works best with three rows of wire connecting between the one set of side tubes.

Frame with Two Sets of Side Tubes

To use two rows slide each set of side tubes approximately 6 inches from the corners. There should be about 6” of open space on either side of the tubes and 6” in the middle. This configuration works best using 5 or 6 rows of hanging wire between both sets of side tubes making 10-12 total wire rows

Frame in Tent With Two Sets of Side Tubes With Plant Hanging in it.

This configuration will accommodate more herb than the one row configuration. Drying around 2.5 lbs strain dependent.

Use One Set Of Side Tubes To Hang Large Branches/Plants. Use Two Sets Of Side Tubes To Hang Small Branches. You can dry more using two sets of side tubes, hanging smaller branches

How to attach the wire

After Frame is Assembled

Unzip the base of the Canna Dry Tent and put that on the base of the frame like showed. Then unzip the rest of the dry tents 4 zippers and pull tent over the frame. Zip up the sides of the tent and tent base then the doors

Wire Being Wrapped Around Tube

Cut wire to 45 inch lengths. Wrap the wire around the side tube 2 times then around the itself 2 times.Take the other end of the wire and wrap it around the opposing tube the same way. Do not wrap the wire too tight around the tube.

Sliding The Wire Up or Down

It should be easy to slide the wire up and down on the tube to accommodate different row heights and makes it easier to work on hanging and tanking off plant material when working on a row. Do not pull the wire taut between the side tubes. There should be some sag or play in the wire. This prevents tubes being pulled in creating better stability for all the wires.